Once you've designated to boot from the flash drive, the on-screen instructions that follow are pretty straightforward, even though the preparation and installation proper may take awhile.
To change your settings, please refer to your computer manual or consult the manufacturer. Download the Update dmg or exe file to a temporary or download directory (please note this directory for reference). Go to the directory where the file was downloaded and double-click the Update_or Update_file. If the computer has additional USB ports, try connecting the USB cable to different USB port. Stop the USB connection, click “Finish”, then remove the battery or disconnect the AC adapter briefly, and then power on the camera again. When the following screen is displayed, reset the camera. On the camera, press the center button of the Control Wheel to reset the camera. Updating the Aircraft Firmware Step 1- Check Battery and SD Card Capacity Ensure the Intelligent Flight Battery and Remote Controller have at least 50% power and there is at least 100MB of free space on the SD card. Download the firmware update package from the official DJI website . Remove the SD card from your PC and insert it into the SD card slot on the Inspire 1 camera. Connect your mobile device to the remote controller, power on the remote controller, and launch the DJI GO app to obtain information about firmware update progress.Confirm you wish to update within the app to continue.Is the [probability] of losing such information greatly increased, if the USB media is still flashing at the time of pulling it out of the computer (as opposed to non-flashing) ?Caching occurs by not writing information immediately to the USB device, and instead keeping it in your PC’s memory (RAM).